Steel RE NU Stainless Steel Coating Page 2 Steel Re-Nu Stainless Steel Coating

Customer Service: 800-272-4620 Technical Assistance: 800-521-3168 Your Best Solution CRC Industries is a worldwide leader in the production of specialty chemicals for maintenance and repair professionals serving industrial, electrical, aviation, automotive and marine markets. CRC is ISO 9001:2008 certified and adheres to the strictest guidelines for quality in all facets of research, development and production. CRC , K&W , Sta-Lube , Marykate and products denoted with and are trademarks of CRC Industries, Inc. 2014 CRC Industries, Inc. Steel Re-Nu DIRECTIONS: Surface Preparation New Steel - Surface must be dry and free of contamination. Remove all weld spatter and grind all rough welds and sharp edges to a smooth contour. For severe exposure (immersion, chemical, etc.), near-white blast clean per SSPC SP 10-63T. For other exposures, blast clean per SSPC SP 6 - 63 to a maximum profile of 1.5 mils. Previously Painted Surfaces - Must be free of oil, grease or other contamination. For best results, spot blast exposed areas to be primed. Power tool brushings may be used for minor touch-up. Application Directions: Surface should be dry and free of rust bloom. Shake well until agitator ball is free. Repeat while using. Best results are obtained when sprayed between 50F and 90F. Spray from 12-15 inches away in light, even coats. The optimum film thickness for CRC Steel Re-Nu is 1.5 to 3.0 mils of dry film. To obtain this thickness via aerosol application, 3 passes of spray are required. Spray the substrate once vertically, once horizontally, and once more vertically for ideal coverage. Additional coats for heavy film can be applied when first coat is dry. For a thickness of 3 mils, repeat the above spray pattern twice. When finished spraying, clean valve by turning can upside down and pressing button until only pressure escapes. If clogging occurs, remove button and clean slot and orifice with fine wire.

Previous Page