Fire Block Foam Flame Resistant Sealant Page 2 Fire Block Foam Flame Resistant Sealant

Customer Service: 800-272-4620 Technical Assistance: 800-521-3168 www.crcindustries.com/ei Your Best Solution CRC Industries is a worldwide leader in the production of specialty chemicals for maintenance and repair professionals serving industrial, electrical, aviation, automotive and marine markets. CRC is ISO 9001:2008 certified and adheres to the strictest guidelines for quality in all facets of research, development and production. CRC , K&W , Sta-Lube , Marykate and products denoted with and are trademarks of CRC Industries, Inc. 2014 CRC Industries, Inc. Fire Block Foam Block Foam e Fire B e B e B Fire Block Foam e B e B e Made in USA DIRECTIONS: Important - read all directions and cautions before use. Always wear gloves, eye protection and work clothes. Use drop cloths. Product is flammable during dispensing - turn off sources of ignition prior to use. Preparation: To promote adhesion, surfaces must be free of oil and dirt. Assemble straw and adapter, then carefully screw this trigger assembly onto valve. With trigger assembly attached, shake well for 30 seconds. Holding the can upside-down, slowly activate trigger until foam begins to dispense. Important: Before starting the job, first practice dispensing onto scrap materials. For best results, apply in temperatures between 65-100F (18-38C). Application: This product should only be dispensed in the UPSIDE-DOWN position. For best results, apply in spaces with 40% or greater relative humidity. Fill gap no more than 1/3 full, allowing room for expansion. Do not overfill. Important: Foam will continue to dispense for a few seconds after releasing the trigger - keep the straw tip moving to reduce the possibility of overfilling. Foam is tack-free in 30 minutes. Excess foam can be trimmed, sanded, caulked or plastered as necessary. Direct sunlight discolors foam if not painted or covered. Clean-up: If wet foam contacts skin, clean immediately with acetone or nail polish remover containing acetone - do not use water. Clean uncured foam with CRC Natural Degreaser. Do not attempt to remove cured foam with solvents - cured foam wears off and is not harmful to health. Storage/Re-Use: To store unused portion, bend straw back onto the knob atop the dispensing trigger. To re-use, remove the straw from the knob, shake well and apply as directed. Store can upright below 90F (32C). TYPICAL PROPERTIES Fire Block Foam UL94 Flammability Rating V-0 Applicable Standards ICC-Evaluation Services (ICC-ESR-1926) approved Yield per can (1/2" bead) 270 linear feet Drytime/tack free 30 minutes Cure time (Full cure) 24 hours Shelf life 12 months ASTM C-518 R-Value 4.5/in (25 mm) ASTM D-1621 Compressive Strength 11 psi ASTM D-1622 Density 1.3-1.8 PCF ASTM D-1623 Tensile Strength 26 psi ASTM D-2856 Closed Cell Content 77% International Building Code compliant International Residential Code compliant BOCA Building Code compliant 1999 Standard Building Code compliant 1997 Standard Building Code compliant California Bureau of Home Furnishings and Insulation compliant Non Fire Block Foam - Easily Catches Fire Fire Block Foam - Flame Self Extinguishes

Previous Page